CONTINUITY TEST
Change 1
2-604.175
TM 9-2320-366-20-1
(1)
Remove nut, lockwasher, terminal lug TL32,
and lockwasher from RH rear marker light
screw.
Discard lockwashers.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter
to terminal lug TL32.
(4)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5)
If continuity is not present, repair wire
3094 from terminal lug TL32 to splice E28
(para 2-45) or replace M1088 rear lights
cable assembly (7-104).
(6)
If continuity is present, repair wire 489
from splice E41 to splice E27 (para 2-45)
or replace M1088 rear lights cable
assembly (para 7-104).
(7)
Install lockwasher, terminal lug TL32,
lockwasher, and nut on RH rear marker
light screw.