TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1111 of 1824

VOLTAGE TEST

Change 1

2-604.179

TM 9-2320-366-20-1

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE

Use care when testing electrical connectors not

to bend connector pins or damage connector

sockets with multimeter probes.

Failure to

comply may result in damage to equipment.

CAUTION

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits, or

cause severe burns or electrical shock.

WARNING

(1) Disconnect LH rear marker light connector

from connector P54.

(2) Set multimeter to volts DC.

(3) Connect positive (+) probe of multimeter

to connector P54.

(4) Connect negative (-) probe of multimeter to

ground.

(5) Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and note reading

on multimeter.

(6) Position main light switch to OFF

(TM 9-2320-366-10-1).

(7) If 12 VDC is not present, repair wire 489

from connector P54 to splice E27 (para

2-45) and go to step 3 of this fault if

required or replace M1088 rear lights cable

assembly (para 7-104) and go to step 1 of

this fault.

(8) Connect LH rear marker light connector to

connector P54.