TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1125 of 1824

TM 9-2320-366-20-1

VOLTAGE TEST

CAUTION

Change 1

2-611

WARNING

NOTE

Model

M1083/M1084/M1085/M1086/

M1090/M1092/M1093/M1094/

M1096

Connector P64 to Splice E20

Splice

M1088

M1089

Connector P64 to Splice E32

Connector P64 to Splice E48

Table 2-12.16.

Composite Taillight Connectors

(1) Disconnect connector P64 from RH

composite taillight assembly.

(2) Set multimeter to volts DC.

(3) Connect positive (+) probe of multimeter to

connector P64.

(4) Connect negative (-) probe of multimeter to

ground.

(5) Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and note

reading on multimeter.

(6) If 12 VDC is not present, repair wire 21

(refer to Table 2-12.16.

Composite

Taillight Connectors) (para 2-45) or

replace M1083/M1084/M1085/M1090/

M1092/M1093/M1094/M1096 rear lights

cable assembly (para 7-84) or M1086/

M1088/M1089 rear lights cable assembly

(para 7-104).

(7) Position main light switch to OFF

(TM 9-2320-366-10-1).

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits,

and cause severe burns or electrical shock.