TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006
CHANGE 3

  TM-9-2320-366-20-1 - Page 1253 of 1824

CAUTION
CONTINUITY TEST
Change 1
2-699
TM 9-2320-366-20-1
NOTE
(1) Remove kick panel (para 16-3).
(2) Disconnect connector clamp from
connector P115.
(3) Disconnect connector P115 from
WTEC III transmission ECU.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter
to PDP, where WTEC III relay K25
terminal 85 was removed.
(6) Connect negative (-) probe of multimeter
to connecter P115 socket 4 and note
reading on multimeter.
(7) If continuity is not present, repair wire
113 from WTEC III relay K25 terminal
85 to connector P115 socket 4 (para 2-45)
or replace WTEC III dashboard cable
assembly (para 7-11).
(8) Connect connector P115 to WTEC III
transmission ECU.
(9) Connect connector clamp to connector
P115.
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.


Back to Top