TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1255 of 1824

CONTINUITY TEST

CAUTION

Change 1

2-701

TM 9-2320-366-20-1

(1) Remove three screws from PDP.

(2) Remove three screws and washers from

PDP.

(3) Lift PDP outward to gain access.

(4) Disconnect connector P51 from connector

J51.

(5) Set multimeter to ohms.

(6) Connect positive (+) probe of multimeter

to PDP, where WTEC III relay K25 terminal

87 was removed.

(7) Connect negative (-) probe of multimeter to

connector J51 pin 2 and note reading on

multimeter.

(8) If continuity is not present, repair wire 490

from WTEC III relay K25 terminal 87 to

connector J51 pin 2 (para 2-45) or replace

WTEC III dashboard cable assembly

(para 7-11).

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

NOTE