TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1287 of 1824
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-733
2-733
2-733
2-733
2-733
CONTINUITY TEST
CONTINUITY TEST
(1)
Disconnect connector PX14 from hazard
lights switch.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
connector PX20-A.
(4)
Connect negative (-) probe of multimeter to
connector PX14-6 and note reading on
multimeter.
(5)
If continuity is not present, repair wire 1568
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Connect connector PX14 to hazard lights
switch.
(7)
Install instrument panel assembly
(para 7-15).
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector PX20-C.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, repair wire 3049
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard
cable assembly (para 7-11).
(5)
If continuity is present, replace flasher unit
(para 7-25).
(6)
Connect connector PX20 to flasher unit.
(7)
Install flasher unit on dashboard with two
washers and screws.
(8)
Install kick panel (para 16-3).
Back to Top
