TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1281 of 1824
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
TM 9-2320-366-20-1
2-727
2-727
2-727
2-727
2-727
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove PDP cover (para 16-2).
(2)
Remove circuit breaker CB74 from PDP.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
PDP, terminal 5, where circuit breaker CB74
was removed.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position main light switch to STOPLIGHT
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 vdc is not present, repair wire 1577
(para 2-45 )or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(8)
Position main light switch to OFF
(TM 9-2320-366-10-1).
(9)
Install circuit breaker CB74 in PDP.
(10)
Install PDP cover (para 16-2).
Back to Top
