Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
Raise cover on connector J95 intervehicular 12
Set multimeter to volts dc.
Connect positive (+) probe of multimeter to
Connect negative (-) probe of multimeter to
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading on
If 12 vdc is not present, go to step 2 of this
If 12 vdc is present, perform Electrical System
Troubleshooting (e48. Side and/or Rear Marker
Lights Do Not Illuminate) if towed vehicle is
FMTV. If towed vehicle is not an FMTV, refer
to towed vehicle TM for troubleshooting
Position main light switch to OFF