TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1445 of 1824

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

2-881

2-881

2-881

2-881

2-881

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuit

and cause severe burns or electrical shock.

CONTINUITY TEST

VOLTAGE TEST

(1)

Remove instrument panel assembly for access

(para 7-15).

(2)

Disconnect connector P18 from turn signal

switch connector.

(3)

Set multimeter to volts dc.

(4)

Connect positive (+) probe of multimeter to

connector P18-4.

(5)

Connect negative (-) probe of multimeter to

ground.

(6)

Position master power switch to on

(TM 9-2320-366-10-1).

(7)

Press windshield washer switch

(TM 9-2320-366-10-1) and note reading on

multimeter.

(8)

If 24 vdc is not present, repair wire

1569

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(9)

Position master power switch to off

(TM 9-2320-366-10-1).

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter to

turn signal switch connector terminal 4.

(3)

Connect negative (-) probe of multimeter to

turn signal switch connector terminal 8.

(4)

Press windshield washer switch

(TM 9-2320-366-10-1) and note reading on

multimeter.

(5)

If continuity is not present, replace turn

signal switch (para 7-26).

(6)

Connect connector P18 to turn signal switch

connector.

(7)

Install instrument panel assembly (para 7-15).