TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 1447 of 1824

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

TM 9-2320-366-20-1

2-883

2-883

2-883

2-883

2-883

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuit

and cause severe burns or electrical shock.

VOLTAGE TEST

(1)

Remove PDP cover (para 16-2).

(2)

Remove three screws and washers from PDP.

(3)

Remove three screws from PDP.

(4)

Lift PDP outward to gain access.

(5)

Disconnect connector J27 from connector P27.

(6)

Set multimeter to volts dc.

(7)

Connect positive (+) probe of multimeter to

connector J27-4.

(8)

Connect negative (-) probe of multimeter to

ground.

(9)

Position master power switch to on

(TM 9-2320-366-10-1).

(10)

Press windshield washer switch

(TM 9-2320-366-10-1) and note reading on

multimeter.

(11)

If 24 vdc is not present, repair wire 1424

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(12)

Position master power switch to off

(TM 9-2320-366-10-1).

(13)

Connect connector J27 to connector P27.

(14)

Install PDP on dashboard with three screws.

(15)

Install three washers and screws in PDP.

(16)

Install PDP cover (para 16-2).