TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1569 of 1824
TM
TM 9-2320-366-20-1
9-2320-366-20-1
E-9. RELAY TEST WIRE
Fabricate the relay test wire according to the following steps. Refer to the following parts list for materials.
Material Description
National Stock
Number
Cut Length
Wire, Electrical (MIL-W-16878)
6 in. (152 mm)
a. Dimensions are in inches (millimeters).
b. Cut a length of wire six inches (152 mm) long.
c. Remove approximately 3/4 in. (19 mm) of electrical insulation from each end of wire.
E-10. TRANSMISSION AUXILIARY OIL COOLER RUBBER SEAL
Fabricate the transmission auxiliary oil cooler rubber seals in accordance with the following parts list.
Part Number
Description
National Stock
Number
Cut Length
inches
mm
MIL-R-6130
Tape, Adhesive, Rubber
24.7
627
E-11. WHEEL BEARING SHIM TOOL REST
Fabricate the wheel bearing shim tool rest according to the following steps.
Refer to the following parts list for
materials.
Part Number
National Stock Number
Description
QQ-T-570
Bar, Metal
a. Dimensions are in inches (millimeters)
b. Cut metal bar to 9.0 inches (228.6 mm) long.
c. De-burr and remove sharp edges from ends of metal bar.
E-12. PNEUMATIC TUBES FABRICATION
Cut pneumatic tubes from bulk tubing stock listed in
Table E-1. Pneumatic Tube Lengths
. Use a fine-toothed
hacksaw or suitable cutting device and cut tubing to required length.
Table E-1. Pneumatic Tube Lengths
Tube Part
Number
Bulk Tubing
Part Number
Cut Length
inches
cm
12414690-001
NT-100-4 (79470)
18.1
46.0
12414690-002
NT-100-4 (79470)
16.0
40.6
12414690-003
NT-100-4 (79470)
15.0
38.1
12414690-004
NT-100-4 (79470)
74.8
190.0
12414690-005
NT-100-4 (79470)
69.7
177.0
E-17
E-17
Back to Top
