TM-9-2320-366-20-1
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-1 - Page 1585 of 1824
TM
TM 9-2320-366-20-1
9-2320-366-20-1
APPENDIX
APPENDIX F
F
TORQUE
TORQUE LIMITS
LIMITS
F-1. GENERAL
This appendix provides general torque limits for screws and nuts used on the vehicle. Special torque limits are shown
in the maintenance procedures for applicable components. Use the general torque limit given in this appendix when
specific torque limits are not given in the maintenance procedure. These general torque limits can not be applied to
screws that retain rubber components. The rubber components will be damaged before the torque limit is reached.
If a special torque limit is not given in the maintenance instructions for a fastener which retains a rubber component,
tighten the screw or nut until it touches metal, then tighten one more turn. Whenever possible, the tightening force
(torque) should be applied to the nut side of the fastener group.
F-2. TORQUE LIMITS
Refer to
Table F-1. Torque Limits for SAE and ANSI Fasteners
for torque limits on standard (SAE and ANSI) screws
and free spinning nuts. Refer to
Table F-2. Torque Limits for SAE and ANSI Prevailing Torque Nuts
for torque
limits on standard (SAE and ANSI) self-locking nuts. Refer to
Table F-3. Torque Limits for Metric Screws and Free
Spinning Nuts
for torque limits on metric screws and free spinning nuts. Refer to
Table F-4. Torque Limits for
Metric Prevailing Torque Nuts
for torque limits on metric self-locking nuts.
F-3. USE OF TORQUE TABLES
(1) Measure the diameter of the screw to be installed.
(2) Count the number of threads per inch.
(3) Under the heading DIAMETER look down the column
until the diameter of the screw is found. (There are
usually two lines beginning with the same diameter.)
(4) Under the heading THREADS PER INCH (SAE and
ANSI) or THREAD PITCH (metric), find the number of
threads per inch that matches the number counted in
step (2).
(5) To find the grade of the screw, match the markings on
the head to the correct picture under CAPSCREW HEAD
MARKINGS on the torque table.
(6) Look down the column under the picture found in step
(5) until the torque limit (lb-ft or N·m) for the diameter
and threads per inch (or thread pitch, in the case of
metric fasteners) of the screw are located.
F-1
F-1
Back to Top
