Install plastic cable ties as required.
(1)
Position front grille on cab with washer and
screw.
(2)
Position two washers and screws in front
grille.
(3)
Tighten screw to 48-60 lb-in. (5-7 N.m).
(4)
Tighten two screws to 24 lb-in. (3 N.m).
(5)
Set multimeter to ohms.
(6)
Connect positive (+) probe of multimeter to
terminal lug TL48.
(7)
Connect negative (-) probe of multimeter to
terminal lug TL62 and note reading on
multimeter.
(8)
If continuity is not present, go to step 8 of
this fault.
NOTE
CONTINUITY TEST
TM 9-2320-366-20-1
Change 1
2-266.3