TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 405 of 1824

CONTINUITY TEST

(1) Remove self-locking nut, washer, terminal

lug TL65, and lockwasher from stud.

Discard self-locking nut and lockwasher.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to terminal lug TL65.

(4) Connect negative (-) probe of multimeter

to terminal lug TL64 and note reading on

multimeter.

(5) If continuity is not present, replace cab to

chassis ground strap (para 7-78).

(6) Install lockwasher and terminal lug TL65

on stud with washer and self-locking nut.

Install plastic cable ties as required.

(7) Position front grille on cab with washer

and screw.

(8) Position two washers and screws in front

grille.

(9) Tighten screw to 48-60 lb-in. (5-7 N.m).

(10) Tighten two screws to 24 lb-in. (3 N.m).

NOTE

TM 9-2320-366-20-1

Change 1

2-266.9