TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006
CHANGE 3

  TM-9-2320-366-20-1 - Page 459 of 1824

Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes.
Failure to comply
may result in damage to equipment.
CAUTION
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability.
Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1)
Remove instrument panel for access
(para 7-15).
(2)
Disconnect connector PX17 from master
power switch connector.
(3)
Position master power switch to on.
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter to
master power switch connector pin 1.
(6)
Connect negative (-) probe of multimeter to
master power switch connector pin 5 and
note reading on multimeter.
(7)
If continuity is not present, replace master
power switch (para 7-18).
(8)
Position master power switch to off.
TM 9-2320-366-20-1
Change 1
2-284.11


Back to Top