TM-9-2320-366-20-1

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 1 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-1 - Page 951 of 1824

VOLTAGE TEST

Change 1

2-604.19

TM 9-2320-366-20-1

(1)

Disconnect connector P58 from RH rear

marker light connector.

(2)

Set multimeter to volts DC.

(3)

Connect positive (+) probe of multimeter

to connector P58.

(4)

Connect negative (-) probe of multimeter

to ground.

(5)

Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and note reading

on multimeter.

(6)

If 12 VDC is not present, repair wire 489

from connector P58 to splice E15

(para 2-45) and go to step 8 of this fault

if required or replace rear lights cable

assembly (para 7-84) and go to step 1

of this fault.

(7)

If 12 VDC is present, replace RH rear marker

light (para 7-38) and go to step 8 of this

fault if required.

(8)

Position main light switch to OFF

(TM 9-2320-366-10-1).

(9)

Connect RH rear marker light connector

to connector P58.

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

CAUTION

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle.

Jewelry can catch on equipment and

cause injury or short across electrical circuits

and cause severe burns or electrical shock.

WARNING

NOTE