TM-9-2320-366-20-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-2 - Page 113 of 1632
TM 9-2320-366-20-2
TM 9-2320-366-20-2
TM 9-2320-366-20-2
TM 9-2320-366-20-2
TM 9-2320-366-20-2
2-999
2-999
2-999
2-999
2-999
VOLTAGE TEST
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
WARNING
(11)
Position winch power switch to off
(TM 9-2320-366-10-1).
(12)
Position PTO switch to off
(TM 9-2320-366-10-1).
(13)
Position master power switch to off
(TM 9-2320-366-10-1).
(1)
Remove four nuts, washers, solenoid bracket,
washers, and
screws.
(2)
Loosen screw and disconnect winch out
solenoid L5 connector from solenoid L5.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
winch out solenoid L5 connector terminal 1.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position master power switch to on
(TM 9-2320-366-10-1).
(7)
Position PTO switch to on
(TM 9-2320-366-10-1).
(8)
Position winch power switch to on
(TM 9-2320-366-10-1).
(9)
Position WINCH IN/OUT switch to OUT
(TM 9-2320-366-10-1) and note reading on
multimeter.
(10)
If 24 vdc is not present, go to step 3 of this
fault.
Back to Top
