TM-9-2320-366-20-2

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 2 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-2 - Page 913 of 1632

CAUTION

Use care when testing electrical connectors.

Do not damage connector pins or sockets

with multimeter probes.

Failure to comply

may result in damage to equipment.

NOTE

Inspect connector pins/sockets for damage,

corrosion, and serviceability.

Check that

connector pins are not pushed back and

are capable of making good contact.

CONTINUITY TEST

Change 1

2-1706.11

TM 9-2320-366-20-2

(1)

Loosen screw in connector J116.

(2)

Disconnect connector J116 from WTEC II

VIM.

(3)

Set multimeter to ohms.

(4)

Connect positive (+) probe of multimeter to

WTEC II VIM connector pin K3.

(5)

Connect negative (-) probe of multimeter to

WTEC II VIM connector pin L2 and note

reading on multimeter.

(6)

If continuity is not present, repair or replace

WTEC II VIM (para 8-6).

(7)

Connect connector PX33 to WTEC II VIM

connector.

(8)

Tighten screw in connector PX33.