TM-9-2320-366-20-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 3 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-3 - Page 940 of 1396

TM 9-2320-366-20-3

7-32. REMOTE CONTROL UNIT REPAIR

This task covers:

a. Controller Removal

b. Controller Installation

c. Toggle Switch Removal

d. Toggle Switch Installation

e. Harness Removal

f.

Harness Installation

g. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

MHC remote control unit removed (TM 9-2320-366-10-1

or TM 9-2320-366-10-2).

Tools and Special Tools

Tool Kit, Genl Mech (Item 46, Appendix C)

Wrench, Torque, 0-75 lb-in. (Item 90, Appendix B)

Materials/Parts

Dispenser, Pressure Sensitive Adhesive Tape

(Item 20, Appendix D)

Adhesive (Item 5, Appendix D)

Nut, Self-Locking (4) (Item 175, Appendix G)

a. Controller Removal.

NOTE

All four controllers are removed the same

way. Boom Up/Down controller shown.

(1) Remove four self-locking nuts (1) from boom up/down

controller (2). Discard self-locking nuts.

(2) Remove boom up/down controller (2) from REMOTE

CONTROL UNIT (3) until connector (4) is accessible.

(3) Disconnect connector (4) from boom up/down controller

(2).

(4) Remove adhesive from seating surface (5).

(5) Loosen jam nut (6) on boom up/down controller (2).

(6) Remove knob (7) from boom up/down controller (2).

(7) Remove jam nut (6) from boom up/down controller (2).

7-190

Change 1