TM-9-2320-366-20-5

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 5 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-5 - Page 160 of 1158

TM 9-2320-366-20-5

17-25. WINCH CONTROL VALVE ASSEMBLY AND BRACKET REPLACEMENT

This task covers:

a. Removal (All Models Except M1090/M1094)

b. Installation (All Models Except M1090/M1094)

c. Removal (M1090/M1094)

d. Installation (M1090/M1094)

e. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Dump body raised to maintenance position

(M1090/M1094) (TM 9-2320-366-10-1).

Engine shut down (TM 9-2320-366-10-1).

Tools and Special Tools

Goggles, Industrial (Item 15, Appendix C)

Pan, Drain (Item 24, Appendix C)

Tool Kit, Genl Mech (Item 46, Appendix C)

Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)

Socket Set, Socket Wrench (Item 34, Appendix C)

Materials/Parts

Dispenser, Pressure Sensitive Adhesive Tape

(Item 20, Appendix D)

Cap and Plug Set (Item 14, Appendix D)

Ties, Cable, Plastic (Item 69, Appendix D)

Oil, Lubricating, OE/HDO 10 (Item 42, Appendix

D)

Rag, Wiping (Item 50, Appendix D)

Packing, Preformed (5) (Item 179, Appendix G)

WARNING

Wear appropriate eye protection when

working

under

vehicle

due

to

the

possibility of falling debris.

Failure to

comply may result in injury to personnel.

a. Removal (All Models Except M1090/M1094).

CAUTION

Cap or plug hoses and connection points to

prevent contamination of hydraulic system.

Failure to comply may result in damage to

equipment.

NOTE

• Remove plastic cable ties as required.

• Tag hoses and connection points prior to

disconnecting.

(1) Disconnect five hoses (1) from winch control valve (2).

17-114