TM-9-2320-366-20-5
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 5 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-5 - Page 176 of 1158
TM 9-2320-366-20-5
17-28. M1089 30K WINCH LEFT/RIGHT HOSE AND TUBING REPLACEMENT
This task covers:
a. Hydraulic Hose and Tubing Locations
b. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-366-10-1).
Tools and Special Tools
Tool Kit, Genl Mech (Item 46, Appendix C)
Pan, Drain (Item 24, Appendix C)
Goggles, Industrial (Item 15, Appendix C)
Wrench, Torque, 0-175 lb-ft (Item 58, Appendix C)
Material/Parts
Dispenser, Pressure Sensitive Adhesive Tape
(Item 20, Appendix D)
Cap and Plug Set (Item 14, Appendix D)
Ties, Cable, Plastic (Item 69, Appendix D)
a. Hydraulic Hose and Tubing Locations.
WARNING
•
Wear appropriate eye protection when working under vehicle due to the possibility of falling
debris. Failure to comply may result in injury to personnel.
•
Prolonged contact with lubricating oil (MIL-L-2104) may cause a skin rash. Skin and clothing that
come in contact with lubricating oil should be thoroughly washed immediately. Saturated clothing
should be removed immediately. Areas in which lubricating oil is used should be well ventilated
to keep fumes to a minimum. Failure to comply may result in injury to personnel.
CAUTION
Cap or plug hoses, tubes, and connection points to prevent contamination of M1089 30K winch
hydraulic system. Failure to comply may result in damage to equipment.
NOTE
• Refer to
Table 17-8. M1089 30K Winch Left/Right Hydraulic Hose and Tubing Locations
for hydraulic
hose and tubing locations on the M1089 30K winches. It may not be necessary to remove all hydraulic
hoses and tubes at one time.
• Tag hoses, tubes, and connection points prior to removal.
• Remove plastic cable ties as required.
• Remove clamps and support brackets as required.
• Position drain pan to collect oil.
17-130
Back to Top
