TM-9-2320-366-20-5

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 5 OF 5

FEBRUARY 2006

CHANGE 3

TM-9-2320-366-20-5 - Page 357 of 1158

TM 9-2320-366-20-5

19-9. EMERGENCY CAB LIFT PROCEDURE

This task covers:

a. Cab Lift

b. Follow-On Maintenance

INITIAL SETUP

Equipment Conditions

Engine shut down (TM 9-2320-366-10-1).

Tools and Special Tools

Tool Kit, Genl Mech (Item 46, Appendix C)

Goggles, Industrial (Item 15, Appendix C)

Gloves, Rubber (Item 13, Appendix C)

Pan, Drain (Item 24, Appendix C)

Cab Support Tool (Item E-4, Appendix E)

Materials/Parts

Cap and Plug Set (Item 14, Appendix D)

Nut, Self-locking (4) (Item 168, Appendix G)

Personnel Required

(2)

a. Cab Lift.

CAUTION

Perform this task in the event that the air/

hydraulic power unit and the back-up hydraulic

pump are inoperative at the same time.

(1) Place drain pan under hydraulic hose (1).

WARNING

Hydraulic fluid (MIL-H-5606) is TOXIC. Wear

protective goggles and gloves; use only in

well-ventilated area; avoid contact with skin,

eyes, and clothes.

Skin and clothing that

come in contact with hydraulic oil should be

washed immediately.

Saturated clothing

should be removed immediately. Failure to

comply may result in injury to personnel.

CAUTION

Cap or plug hose and connection point to

prevent contamination of hydraulic system.

Failure to comply may result in damage to

equipment.

(2) Disconnect hydraulic hose (1) from 90-degree fitting (2).

(3) Remove four self-locking nuts (3), washers (4), screws

(5), from cab hydraulic latch (6) and cab support

assembly (7). Discard self-locking nuts.

19-45