TM-9-2320-366-20-5
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; UNIT MAINTENANCE; VOLUME NO. 5 OF 5
FEBRUARY 2006
CHANGE 3
TM-9-2320-366-20-5 - Page 46 of 1158
TM 9-2320-366-20-5
17-10
Change 2
17-4.
M1084/M1086 HOOK BLOCK AND CABLE ASSEMBLY REPLACEMENT/REPAIR
(CONT)
(3)
Install hook eye (8) on swivel hook (2) with self-
locking nut (9).
(4)
Install hook eye (8) in hook block (10) with screw
(11) and nut (12).
(5)
Install cotter pin (13) in nut (12).
e. Installation.
(1)
Cut off a short length of cable 2-3 in. (51-76 mm)
and set aside.
(2)
Place wedge socket (1) in vise.
(3)
Make a loop in the cable (2) and put free (dead) end
of cable back through hole in wedge socket.
WARNING
Cable can become frayed or contain
broken wires.
Wear heavy leather-palmed
gloves when handling cable.
Frayed or
broken wires can injure hands.
Failure to
comply may result in injury to personnel.
NOTE
•
If the end of the cable is welded, the
welded end should be cut off.
This will
allow the distortion of the cable strands,
caused by the sharp bend around the
wedge, to adjust themselves at the end
of the line.
•
Make sure there are no rough edges on
the wedge socket.
Back to Top
