Change 1
2-641
TM 9-2320-366-34-1
RESISTANCE TEST
(1)
Remove control valve module (para 7-10).
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
internal wiring harness 24-pin connector
pin G2.
(4)
Connect negative (-) probe of multimeter to
internal wiring harness 24-pin connector
pin F3 and note reading on multimeter.
(5)
If resistance is less than 300 ohms or
greater than 2000 ohms, replace
transmission internal wiring harness
(para 7-13).
(6)
Install control valve module (para 7-10).