TM-9-2320-366-34-2
M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)
TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 2 OF 4
AUGUST 2005
CHANGE 2
TM-9-2320-366-34-2 - Page 326 of 1434
TM 9-2320-366-34-2
7-2
Change 2
Section II.
MAINTENANCE PROCEDURES
7-2.
TORQUE CONVERTER REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Cleaning/Inspection
d.
Assembly
e.
Installation
f.
Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Transmission mounted on maintenance stand (para 7-
5).
Tools and Special Tools
Tool Kit, Genl Mech (Item 78, Appendix B)
Wrench, Torque, 0-175 lb-ft. (Item 92, Appendix B)
Gage, Profile (TM 9-2320-366-20)
Caliper, Vernier (Item 11, Appendix B)
Caliper, Micrometer Inside (Item 10, Appendix B)
Straight Edge (Item 71, Appendix B)
Gage Set, Telescoping (Item 24, Appendix B)
Gage, Depth, Micrometer (Item 25, Appendix B)
Pan, Drain (Item 43, Appendix B)
Inserter, Bearing and Bushing (TM 9-2320-366-20)
Socket Wrench Attachment, Screwdriver (Item 61,
Appendix B)
Goggles, Industrial (Item 28, Appendix B)
Gloves, Rubber (Item 26, Appendix B)
Chain, Welded (TM 9-2320-366-10)
Tools and Special Tools (Cont)
Adapter (3/8 to 1/2") (NSN 5120-01-335-0701)
Socket Wrench Attachment, Screwdriver (3/4
hex, 1/2 drive) (NSN 5120-01-357-3468)
Materials/Parts
Packing, Retainer (Item 304, Appendix F)
Washer, Seal (Item 435, Appendix F)
Sealring (Item 411, Appendix F)
Spring, Flat (13) (Item 427, Appendix F)
Packing, Retainer (Item 303, Appendix F)
Bolt, Machine (2) (Item 14, Appendix C)
Washer, Flat (2) (Item 95, Appendix C)
Rag, Wiping (Item 60, Appendix C)
Solvent, Dry Cleaning (Item 83, Appendix C)
Lubricating Oil, Engine (Item 49, Appendix C)
Personnel Required
(2)
a. Removal.
(1)
Rotate transmission on maintenance stand so that
torque converter module (1) is in up position.
(2)
Remove retaining ring (2) from torque converter
module (1).
WARNING
Use care when removing retaining rings.
Retaining rings are under tension and
can act as projectiles when released.
Failure to comply may result in injury to
personnel.
NOTE
Perform steps (2) through (6) on trans-
missions prior to S/N 6510165560.
Back to Top
