TM-9-2320-366-34-3

M1083 SERIES, 5 TON, 6x6, MEDIUM TACTICAL VEHICLES (MTV)

TECHNICAL MANUAL; MAINTENANCE INSTRUCTIONS; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME NO. 3 OF 4

AUGUST 2005

CHANGE 2

TM-9-2320-366-34-3 - Page 192 of 1178

TM 9-2320-366-34-3

15-7. CAB WINDSHIELD, SIDE WINDOW AND DOOR SIDE WINDOW

REPLACEMENT (CONT)

CAUTION

While twine is being removed from inside of

cab, always tap behind the twine (with soft

head hammer) on outside of cab to seat seal.

Always start from RH lower part of windshield

and work to the LH side of vehicle. DO NOT

start tapping at the middle of the windshield.

Failure to comply may result in damage to

equipment.

(6) Remove RH side of twine until twine is 12 in. (305 mm)

up RH side on windshield (1) as shown.

(7) Remove LH side of twine until twine is 12 in. (305 mm)

up LH side of windshield (1) as shown.

CAUTION

After using windshield setting tool, tap bottom

section of seal lightly with soft head hammer to

ensure proper fit with cab. Use caution not to

hit glass.

Failure to comply may result in

damage to equipment.

(8) Insert bottom of seal (2) evenly with cab (3) using

windshield setting tool and soft head hammer.

(9) Pull down on LH and RH top corners (4 and 5) of

windshield (1).

15-120.4

Change 1