TM-9-2320-386-24-1-1
2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 1 OF 2
MAY 2001
TM-9-2320-386-24-1-1 - Page 398 of 1078
0097 00-2
TM 9-2320-386-24-1-1
0097 00
MAGNETIC SPEED SENSOR REPLACEMENT (Contd)
REMOVAL
1.
Remove nut (2) and two clamps (3) from engine (1).
2.
Remove connector (7) from magnetic speed sensor plug (6)
3.
Loosen jamnut (4) and remove sensor (5) from flywheel housing (8).
INSTALLATION
NOTE
Before tightening jamnut on sensor, adjust sensor 1-1/4 turns out
from flywheel. Nut functions as a jamnut to hold the sensor in
position.
1.
Install sensor (5) on flywheel housing (8) and tighten jamnut (4).
2.
Install sensor wires into two clamps (3) and install clamps (3) on engine (1) with nut (2).
3.
Install two leads 428 and 429 with connector (7) on magnetic speed sensor plug (6).
4.
Connect battery ground cable (WP 0121 00).
Back to Top
