TM-9-2320-386-24-1-1
2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 1 OF 2
MAY 2001
TM-9-2320-386-24-1-1 - Page 806 of 1078
DRAIN SYSTEM
WARNING
Accidental or intentional introduction of liquid contaminants into
the environment is in violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use, and disposal of these liquids. Failure to
do so may result in injury or death.
NOTE
Have drainage container ready to catch oil.
1.
Remove cap (1) from lockplate (2).
2.
Remove drainplug (4) and gasket (5) from reservoir (3). Discard gasket (5).
NOTE
Allow reservoir to drain completely before performing step 3.
3.
Inspect sight glass (6). Replace if damaged.
4.
Install new gasket (5) and drainplug (4) on reservoir (3).
5.
Install cap (1) on lockplate (2).
FILL SYSTEM
1.
Remove cap (1) from lockplate (2).
NOTE
Correct oil level can be verified by checking the sight glass.
2.
Add oil (WP 0023 00) to reservoir (3), filling system until oil level is centered in sight glass (6).
3.
Install cap (1) on lockplate (2).
4.
Operate winch (TM 9-2320-386-10), as follows:
a. Unwind cable 32-48 ft (10-15 m).
b. Rewind and stow cable.
5.
Add oil to reservoir (3) to obtain correct oil level, if necessary.
0213 00-2
TM 9-2320-386-24-1-1
0213 00
FRONT WINCH HYDRAULIC SYSTEM SERVICING (Contd)
Back to Top
