TM-9-2320-386-24-1-2

2-1/2-TON, 6X6, M44A3 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; EXTENDED SERVICE PROGRAM (ESP); UNIT, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL; VOLUME 2 OF 2

MAY 2001

TM-9-2320-386-24-1-2 - Page 473 of 636

0373 00-2

TM 9-2320-386-24-1-2

0373 00

TRANSMISSION MANUAL SELECT SHAFT AND SEAL REPLACEMENT (Contd)

REMOVAL

CAUTION

Clean around seal area to prevent entry of dirt. Damage may

occur to transmission if dirt enters.

1.

Remove retainer pin (4) from manual select shaft (5) and transmission (1).

2.

Position shift lever seal remover over seal (6) and turn shift lever seal remover clockwise to thread

into seal (6).

3.

Remove nut (3), detent lever (2), and manual select shaft (5) from transmission (1).

4.

Tighten screw of shift lever remover and remove seal (6) and shift lever seal remover from

transmission (1). Discard seal (6).

INSTALLATION

1.

Apply oil-soluble grease to lip of new seal (6).

2.

Using shift lever seal installer, install seal (6) on transmission (1).

3.

Insert manual select shaft (5) through seal (6) on transmission (1) and install detent lever (2) on

manual select shaft (5) with nut (3). Tighten nut (3) 15-20 lb-ft (20-27 N

•

m).

4.

Install retainer pin (4) on manual select shaft (5) and transmission (1).

5.

Install transmission control valve (WP 0371 00).