TM-9-2320-387-10

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

OPERATOR’S MANUAL

OCTOBER 2001

CHANGE 1

TM-9-2320-387-10 - Page 163 of 277

TM 9-2320-387-10

WARNING

Exhaust system components are hot after prolonged vehicle use.

Ensure exhaust system components are cool before removing/

installing exhaust assembly. Failure to do this may result in injury to

personnel.

NOTE

Any

items removed for fording must be stowed for reuse.

(4) Remove three locknuts (191, washers (111, capscrews (121, and washers (11)

securing tailpipe (13) to muffler (18).

(5) Remove two nuts (17),lockwashers (161, and U-bolt (14) securing tail-

pipe (13) to clamp (15).

(6) Remove tailpipe (13) and gasket (10) from muffler (18).

(7) Install two rubber isolators (7) into wheelhouse (8). To ease installation,

wet rubber isolators (7) with water.

(8) If isolators (7) cannot be installed easily, check alignment of holes in

wheelhouse (8) and reinforcement bracket (5). ‘Ib align holes, loosen capscrews (6)

securing reinforcement bracket (5) to wheelhouse (8). Align holes in wheelhouse (8)

and reinforcement bracket (5) and tighten capscrews (6). Install isolators (7).

(9) Install exhaust assembly (9) and gasket (10) on muffler (18) with three

washers (ll), capscrews (121, washers (111, and locknuts (19).

(10)

Install exhaust assembly (9) on wheelhouse (8) with two washers (4) and

locknuts (3).

2-115