TM-9-2320-387-10
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
OPERATOR’S MANUAL
OCTOBER 2001
CHANGE 1
TM-9-2320-387-10 - Page 172 of 277
TM 9-2320-387-10
2-124
Change 1
.
WARNING
.
Do not operate vehicle without windshield assembly positioned upright
and the B-pillar securely attached. Operation of vehicle without these
structures in place may result in injury to personnel and damage to
equipment.
NOTE
Before lowering windshield on vehicles equipped with retention
bracket, the windshield retention bracket must be removed. Notify
unit maintenance.
a. Lowering Windshield Assembly.
(1)
Remove two hitch pins (3) from inside hinge pins (4) and remove hinge
pins (4).
(2)
Lower windshield assembly (5) to hood and secure windshield assembly (5)
to four footman loops (2) with two straps (1).
b. Raising Windshield Assembly.
(1)
Remove two straps (1) from four footman loops (2) securing windshield
assembly (5) to hood.
(2)
Raise windshield assembly (5).
NOTE
Notify unit maintenance to install windshield retention bracket.
(3)
Secure windshield assembly (5) with two inside hinge pins (4) and hitch
pins (3).
2-51. GENERAL
a.
This section provides operating instructions for components found on M1113
shelter carriers.
b.
Refer to para. 2-2a for stowage location of fire extinguisher on S250 shelter
carrier. Refer to para. 2-29 for operation of fire extinguisher.
2-53. WINDSHIELD ASSEMBLY OPERATION
Section V. S250 SHELTER CARRIER OPERATION
2-52. S250 SHELTER CARRIER OPERATION REFERENCE INDEX
2-53.
Windshield Assembly Operation
2-124
2-54.
Removal and Installation of Two-Man Crew Area
2-126
Soft Top Enclosure
2-55.
Removal and Installation of S250 Shelter Carrier
2-130
Rear Suspension Tiedown Kit
REF.
TITLE
PAGE
PARA.
NO.
Back to Top
