TM-9-2320-387-10
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
OPERATOR’S MANUAL
OCTOBER 2001
CHANGE 1
TM-9-2320-387-10 - Page 250 of 277
G-1. SCOPE
This appendix gives lubrication requirements for the M1113/M1114 vehicles which
are the responsibility of the operator/crew.
G-2. GENERAL LUBRICATION REQUIREMENTS
a. Maintaining Lubricant Levels.
Lubricant levels must be checked as
specified in the PMCS (chapter 2, section 2) and table G-1, Lubrication. Steps must
be taken to replenish and maintain lubricant levels.
WARNING
• Drycleaning solvent P-D-680 is TOXIC and flammable. Wear
protective goggles and gloves, use only in well-ventilated area,
avoid contact with skin, eyes, and clothes, and do not breathe
vapors. Keep away from heat and flame. Never smoke when
using solvent. The flashpoint for type I drycleaning solvent is 100°F
(38°C), and for type II, is 138°F (59°C). Failure to comply may
result in injury or death to personnel.
• If personnel become dizzy while using cleaning
solvent,
immediately get fresh air and medical help. If solvent contacts skin
or clothes, flush with cold water. If
solvent contacts eyes,
immediately flush eyes with water and get medical attention.
b. Cleaning Fittings Before Lubrication.
Clean parts with drycleaning
solvent P-D-680 or equivalent. Dry before lubricating.
NOTE
Dotted arrow points indicate lubrication on both sides of the
equipment.
c. Lubrication After Fording.
Following fording operation, lubricate all
fittings below fording depth and check submerged gear boxes for presence of water.
d. Lubrication After High-Pressure Washing.
After a thorough washing,
lubricate all grease fittings and oil can points outside and underneath vehicle.
e. Localized Views.
A reference to the appropriate localized view is given
after most lubrication entries. Localized views begin on page G-11.
APPENDIX G
LUBRICATION INSTRUCTIONS
TM 9-2320-387-10
G-1
Back to Top
