TM-9-2320-387-10

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

OPERATOR’S MANUAL

OCTOBER 2001
CHANGE 1

  TM-9-2320-387-10 - Page 253 of 277

TM 9-2320-387-10
G-4
Change 1
USAGE
FLUID/LUBRICANT
CAPACITIES
Steering
Dexron
®
II or
1 qt (0.95 L)
All Temperatures
System
Dexron
®
III
w/Cooler
1.25 qt (1.18 L)
Upper and
GAA
As Required
All Temperatures
Lower Ball
(MIL-G-10924)
Joints, Tie Rod
Ends, Pitman
Arm, Propeller
Shafts, etc.
Hinges, Cables, OE/HDO
As Required
All Temperatures
and Linkages
OE/HDO 15/40 (Grade 15W-40) lubricant may be used when expected temperatures
are above +5°F (-15°C). If OEA lubricant is required to meet the temperature
ranges prescribed in the lubrication table, then the OEA lubricant is to be used in
place of OE/HDO 10 lubricant for all temperature ranges. If operating conditions
are severe or abnormal, service chassis lubrication points at 1,000 mi (1,609 km).
Door Latches
PL-S
As Required
All Temperatures
and Wire
(VV-L-800)
Handle Lock
GREASE, WIRE ROPE
(MIL-G-18458)
ALL TEMPERATURES
EXPECTED
TEMPERATURES
Table G-1. Lubrication (Cont’d).
FUEL REQUIREMENTS — TEMPERATURE LIMITS (VV-F-800)
Grade DF2 Fuel
For use above +10°F (-12°C)*
Grade DF1**
For use below +10°F (-12°C) to above -20°F (-29°C)
Grade DFA
For use below -20°F (-29°C)
Grade JP-8
All Temperatures
* Temperature limits may vary, dependent on the cloud point of the
actual DF2 fuel being supplied in the geographical area.
** DF1 is not normally procured in CONUS or OCONUS. Refineries will
blend DF2 with kerosene to meet temperature requirements of DF1.


Back to Top