TM-9-2320-387-24-1
TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 1
DECEMBER 1997
CHANGE 1
TM-9-2320-387-24-1 - Page 23 of 1205
TM
9-2320-387-24-l
.I,
-
-
3.1. ENG&dE,_tNE,
ANO rOmR
SEERING
011
COOLER
ASEMILY
3. Un page 3-12, you find paragraph 3-8 with the detailed procedure for replacing the oil cooler assembly
d. DETAILED MAINTE NANCE PROCEDURES:
Detailed maintenance procedures include everything
you must do to accomplish a basic maintenance task. Unless otherwise stated, general mechanic’s
automotive tool kit will be used for maintenance of this vehicle.
L Before beginning the maintenance task, look through the procedure. You must familiarize yourself
with the entire maintenance procedure of para. 3-8: Engine, ‘D-ansmission, and Power Steering Oil
Cooler Assembly Maintenance. The task includes a. Removal, b. Installation, and c. Cleaning and
Inspection.
2. The ten basic headings listed under INITIAL SETUP outline task conditions, materials, special
tools, manpower requirements, and special conditions. The headings are:
ADDlicable Models: Any models that require a particular maintenance task. If a maintenance task
covers all models, then this heading will not be used.
Test Eauinment:
Test equipment needed to complete a task. If test equipment is not required, this
heading will not be used.
Tools: These are common tools and general mechanic tool sets required to perform
maintenance tasks. These common tools should be on hand to properly perform the task. Torque
wrenches are required for many tasks; the proper torque wrench should be available to tighten
mounting hardware.
SDecial Tools: Those special tools needed to complete a maintenance task. If no special tools are
needed, this heading will not be used.
If you don’t have one of these special tools, requisition it (before starting the task) using the data
supplied in TM 9-2320-387-24P, the repair parts and special tools list for this level of maintenance.
Special tools are located in section III.
Materials/Parts:
This heading lists only mandatory replacement materials or parts (gaskets,
O-rings, sealant, etc.). To replace other unservicable parts, refer to TM 9-2320-387-2413 for requisition
data. If no mandatory replacement materials/parts are required, this heading will not be used.
xii
Back to Top
