TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 1231 of 1555

TM 9-2320-387-24-2

33-2

Change 1

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Materials/Parts

Locknut (Appendix G, Item 174)

Manual References

TM 9-2320-387-10

TM 9-2320-387-24P

Equipment Condition

• Hood raised and secured (front mounts only)

(TM 9-2320-387-10).

• Left rear underbody armor removed (M1114 only)

(para. 11-37).

• Right rear underbody armor removed (M1114

only) (para. 11-39).

Maintenance Level

General support

1.

Remove locknut (2), washer (1), capscrew (7), washer (8), and spacer (9) from sleeve (4), upper

cushion (5), lower cushion (10), body bracket (3), and frame bracket (6). Discard locknut (2).

2.

Place jack under body reinforcements adjacent to body mount to be removed.

3.

Raise body far enough to separate upper cushion (5) from lower cushion (10) and remove sleeve (4),

upper cushion (5), and lower cushion (10).

b. Installation

1.

Install lower cushion (10), upper cushion (5), and sleeve (4) between body bracket (3) and frame

bracket (6).

2.

Lower body and align lower cushion (10), sleeve (4), upper cushion (5), and body bracket (3) and

secure with spacer (9), washer (8), capscrew (7), washer (1), and locknut (2). Tighten locknut (2) to 90

lb-ft (122 N

•

m).

NOTE

• Replacement procedures for intermediate and rear body mounts

are identical.

• On front body mounts, capscrew is inserted down through upper

cushion.

• This procedure covers left intermediate body mount.

a. Removal

33-3. BODY MOUNT REPLACEMENT

This task covers:

a. Removal

b. Installation