TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 134 of 1555

TM 9-2320-387-24-2

1 O-60. WINDSHIELD

WIPER ARM PIVOT MAINTENANCE

This task covers:

a.

Repair (Optional)

b.

Removal

c.

Installation

INITIAL

SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Manual References

TM 9-2320-387-24P

Equipment

Condition

l

Windshield wiper linkage removed (para. 10-61).

l

Windshield wiper blade and arm removed

(para. 10-62).

Maintenance

Level

Unit

a. Repair (Optional)

NOTE

Steps 1 through 3 are an alternative repair for the windshield

wiper arm pivot. Repair can be left up to the discretion of the

commander.

For easy handling, use of an old wiper arm as a hole guide is

recommended. This will also protect the splined surface of the

pivot.

Use roll pin (5315-01-027-4759) for repair.

1.

Center punch side of wiper arm (1). Position wiper arm (1) so it is horizontal for drilling.

2.

Drill a 3/32-in. (2.4-mm) hole halfway through center shaft (2). Remove old wiper arm (1) and

continue drilling all the way through shaft (2) and cap.

3.

Using

a

small hammer or punch, drive roll pin (3) into hole until it

is

flush with the

surface.

Replace

original wiper arm (1).

10-101