TM-9-2320-387-24-2

TRUCK, UTILITY: S250 SHELTER CARRIER, 4X4, M1113

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE, VOLUME 2

DECEMBER 1997

CHANGE 1

TM-9-2320-387-24-2 - Page 379 of 1555

TM 9-2320-387-24-2

12-4

Change 1

12-4.1. ENGINE/CREW COMPARTMENT HEATER INLET PIPE REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Manual References

TM 9-2320-387-24P

Equipment Condition

Heat shield removed (para. 12-2).

General Safety Instructions

Do not touch hot exhaust system components with

bare hands.

Maintenance Level

Unit

.

WARNING

.

Do not touch hot exhaust system components with bare hands.

Severe injury may result.

1.

Remove clamp (4) and inlet pipe (3) from muffler (5).

2.

Remove clamp (2) and inlet pipe (3) from heater (1).

1.

Install clamps (2) and (4) on inlet pipe (3).

2.

Install inlet pipe (3) on heater (1) and tighten clamp (2).

3.

Install inlet pipe (3) on muffler (5) and tighten clamp (4).

b. Installation

a. Removal