TM-9-2320-428-10
TRUCK, CARGO, 8X8, M977
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-428-10 - Page 978 of 1072
POST TOWING PROCEDURE
NOTE
•
This post towing procedure is applicable to a HEMTT series vehicle
that has been towed from the front ONLY (refer to tow HEMTT-front
lift for further information).
•
If disabled vehicle is either a BASE or A2 model HEMTT series
vehicle (refer to data plate on inside of driver side door), complete
Step (1).
•
If disabled vehicle is an A4 model HEMTT series vehicle (refer to data
plate on inside of driver side door), skip to Step (2).
1.
Perform the following to disabled vehicle:
a.
Remove two axle restraint chains (1) from around frame rails (2) and No. 2 axle
(3).
2
3
1
Figure 3.
b.
Return two axle restraint chains (1) to wrecker stowage.
c.
Install propeller shaft between transfer case and No. 3 axle.
NOTE
•
This post towing procedure is applicable to a HEMTT series vehicle
that has been towed from the front ONLY (refer to tow HEMTT-front
lift for further information).
•
If disabled vehicle is an A4 model HEMTT series vehicle (refer to data
plate on inside of driver side door), complete Step (2).
2.
Perform the following to disabled vehicle:
a.
Remove two axle restraint chains (1) from under engine shroud (2), around
frame rail (3), and No. 2 axle (4).
TM 9-2320-428-10
0153
0153-4
Back to Top
