TM-9-2320-428-10

TRUCK, CARGO, 8X8, M977

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-428-10 - Page 992 of 1072

REMOVE WHEEL AND TIRE ASSEMBLY - Continued

8.

Using jack (1), lower vehicle until flat wheel and tire assembly (7) is just touching

ground.

9.

Tilt top of flat wheel and tire assembly (7) forward, while assistant raises jack (1)

slightly. Wheel and tire assembly (7) should move forward.

10.

Repeat Steps (8) and (9) to walk flat wheel and tire assembly (7) off studs (8).

11.

Remove flat wheel and tire assembly (7) and lean flat wheel and tire assembly against

vehicle.

END OF TASK

INSTALL WHEEL AND TIRE ASSEMBLY

NOTE

Tire tread is non-directional. Vehicle operation is not affected by direction

of traction bars.

1.

With aid of an assistant, roll wheel and tire assembly (1) up to axle (2).

2

1

3

Figure 12.

NOTE

Check that spare wheel and tire assembly wheel dish is in same position

as flat wheel and tire assembly wheel dish. Deep side of wheel dish will

face toward vehicle on four front wheels. Deep side of wheel dish will face

away from vehicle on four rear wheels except M984A. All eight wheels

on M984A are installed with deep side of wheel dish facing toward

vehicle.

TM 9-2320-428-10

0155

0155-10