TM-9-2320-429-10

TRUCK, TANK, 8X8, M978

TECHNICAL MANUAL; OPERATOR'S MANUAL

JUNE 2009

TM-9-2320-429-10 - Page 687 of 1096

FUEL SERVICING (DUST CAPS ON SERVICING HOSES) - Continued

38.

Set V3 SUCTION LINE VALVE handle (10) to OPEN position.

FLAMMABLE

NO SMOKING WITHIN 50 FE T

10

Figure 10.

FUEL SERVICING (FUEL SERVICE NOZZLES INSTALLED ON SERVICING HOSES)

NOTE

•

Driver side servicing hose is shown in this procedure. Procedure for

using passenger side servicing hose is same except where noted.

•

There are two different models of tanker module covered. Older

models use dust caps to cover ends of both servicing hoses when

not in use. Those procedures are called out infuel servicing (dust

caps installed on servicing hoses) . Newer models of tanker modules

have rubber tie down strap to secure fuel service nozzle (which is not

normally removed between uses) in stowage position. The

procedures for these models are listed below.

1.

Disengage hose reel tension knob (1).

////////////////////////////////////////////////////////////////////////////////////

TM 9-2320-429-10

0114

0114-11

////////////////////////////////////////////////////////////////////////////////////

////////////////////////////////////////////////////////////////////////////////////////////////////////////////////