TM-9-2320-434-10
TRUCK, LOAD HANDLING SYSTEM (LHS), 8X8, M1120
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-434-10 - Page 513 of 1324
LOADING CONTAINER - Continued
3.
Back vehicle to within 9 ft. (2.7 m) and align with container.
4.
Cycle LHS to unload until FLA upper hooks are visible just below top edge of container.
5.
Ensure FLA configured for container:
a.
Slide arms pinned if needed.
b.
Lower container locks unlocked.
c.
Correct hook in slide arm.
6.
Back vehicle up until FLA contacts container, aligning hooks with container corner
openings.
7.
Cycle LHS to load until hooks are above container.
8.
Continue backing up vehicle until hooks are positioned over container.
9.
Cycle LHS to unload to engage hooks into container top corners.
10.
Continue to cycle LHS until lower locks are low enough to engage container bottom
corners.
11.
Back up vehicle to engage FLA lower locks in container corners. Steer vehicle to align
lower locks with container.
12.
Check:
a.
Upper hook thumb engaged.
b.
Lower locks flush.
c.
Sliders positioned straight ahead, and clean of debris.
13.
Lock lower locks to container; handle straight up, lock plate over handle and handnut.
14.
Lock other side.
15.
Cycle LHS to LOAD to lift container onto vehicle.
16.
Observe clearance between container and slider guides on both sides to ensure
container is centered during loading.
17.
Fully load container until LHS NOT TRANSIT light goes out.
18.
Pin transit locks in locked position, RH and LH.
19.
Verify container is properly loaded onto the vehicle.
END OF TASK
TM 9-2320-434-10
0063
0063-3
Back to Top
