TM-9-2320-435-10
TRUCK, COMMON BRIDGE TRANSPORT (CBT), 8X8, M1977
TECHNICAL MANUAL; OPERATOR'S MANUAL
JUNE 2009
TM-9-2320-435-10 - Page 246 of 1168
OPERATION - Continued
CAUTION
To avoid damage to equipment, have an assistant act as a ground guide
when backing up vehicle.
19.
Set transmission range selector (15) to R (reverse).
20.
Push in PARKING BRAKE control (13) and release service brake pedal (14).
21.
Back up vehicle while steering as necessary to align tip of LHS hook (21) under BAP
hook bar (22), stop vehicle.
NOTE
Ensure tip of LHS hook is slightly below and in line with middle of BAP
hook bar.
22.
Set transmission range selector (15) to N (neutral), and apply service brake pedal
(14).
NOTE
If LHS hook and BAP hook bar are not properly engaged, move vehicle
away from the BAP and repeat Steps (20) and (21).
23.
Move joystick (20) to LOAD until LHS hook (21) engages BAP hook bar (22).
24.
Install bail bar lock (23) on LHS hook (21) with pin (24) and lock pin (25).
25.
Release service brake pedal (14).
26.
Move joystick (20) to LOAD.
27.
Set HIGH IDLE switch (19) to ON position.
28.
To ensure that BAP runners engage LHS rear rollers, steer vehicle straight under the
BAP as the BAP rises.
29.
Pull out PARKING BRAKE control (13) when BAP runners come onto LHS rear rollers,
and the BAP clears the ground.
30.
Set HIGH IDLE switch (19) to OFF position.
WARNING
When NO TRANSIT indicator is illuminated, vehicle may be maneuvered
in the immediate vicinity of the loading/unloading site. However, vehicle
TM 9-2320-435-10
0040
0040-14
Back to Top
