TM-9-2330-238-14
CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1992
TM-9-2330-238-14 - Page 83 of 462
TM
9-2330-238-14
2-18.
USE OF 220-VOLT
POWER
CABLE
(M313,
M447,
M447C,
AND
M750)
(Con’t).
(4)
Unbuckle
strap
(3) holding
end of power
cable
(4) to cable
reel (1).
NOTE
On M313,
spring (Appendix
C) must first be removed
from end of power
cable before
it
can be unreeled.
(5)
Unreel
and remove
power
cable
(4) from reel barrel
(6).
(6)
Connect
one end of power
cable
(4) to connector
at power inlet housing
at lower curbside
corner of
van body.
Connect other end of power
cable
to external
power
source.
b.
Reeling
220-volt
Power
Cable.
(1)
Disconnect
power cable
(4) from external power source and from connector
at power inlet housing
at
lower curbside
corner
of van body.
(2)
Place
end of power
cable
(4) in hole
of reel barrel
(6). Using
handcrank
(9) or drive
shaft wrench
(M313) rewind
power
cable
onto
cable
reel (1). Secure
free end of power
cable
to cable
reel with strap
(3).
(3)
Lock cable
reel (1) by inserting
cotter
pin (7) through
hole
in reel shaft collar
(8) and reel shaft (5).
NOTE
On M313,
power
cable
Is secured
In stowed
position
with spring
(Appendix
C).
(4)
Install
nylon
cover
(2) to end of power
cable
(4), Chain of nylon
cover
should
be wrapped
around
cable
reel (1) to help
secure
power
cable.
(5)
Install
canvas
cover
on cable
reel (1).
TA701931
2-31
Back to Top
