TM-9-2330-238-14
CHASSIS, SEMITRAILER: 6-TON, 4-WHEEL M295A1; SEMITRAILER, VAN: EXPANSIBLE, 6-TON, 4-WHEEL M313; SEMITRAILER, VAN: SHOP, FOLDING SIDES, 6-TON, 4-WHEEL M447 AND M447C; SEMITRAILER, VAN: REPAIR PARTS, SHOP EQUIPMENT, 6-TON, 4-WHEEL M749; SEMITRAILER, VAN: REPAIR PARTS STORAGE, 6-TON, 4-WHEEL M750
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL
JULY 1992
TM-9-2330-238-14 - Page 88 of 462
TM
9-2330-238-14
LUBRICATION
CHART
CHASSIS,
SEMITRAILER:
6-TON,
4-WHEEL,
M295A1
SEMITRAILER,
VAN: EXPANSIBLE,
6-TON,
4-WHEEL,
M313
SEMITRAILER,
VAN: SHOP, FOLDING
SIDES,
6-TON,
4-WHEEL,
M447 AND M447C
SEMITRAILER,
VAN: REPAIR PARTS, SHOP
EQUIPMENT,
6-TON,
4-WHEEL,
M749
SEMITRAILER,
VAN: REPAIR PARTS STORAGE,
6-TON,
4-WHEEL
M750
Intervals
(on-condition
or
hard
time)
and
related
man-hour
times
are based
on normal
operation.
The
man-hour
time specified
is the time you need to do all
services
prescribed
for
a
particular
interval.
De-
crease
the
intervals
if your
lubricants
are contami-
nated,
or
if you
are
operating
equipment
under
adverse conditions,
including
longer-than-usual
op-
erating
hours. The intervals
may be extended
during
periods
of low activity.
If extended,
adequate
preser-
vation
precautions
must be taken.
Dotted
leader lines indicate
lubrication
is required
on
both
sides
of the equipment.
WARNING
Dry
cleaning
solvent,
P-D-680,
is toxic
and
flammable.
Always
wear
protective
goggles
and
gloves,
and use only in a well-ventilated
area.
Avoid
contact
with
skin,
eyes,
and
clothes,
and DO NOT breathe
vapors.
DO NOT
use
near
open
flame
or excessive
heat.
The
solvent’s
flash
point
is
100°F-138°F
(38°C-59°C).
If you become
dizzy while using
cleaning
solvent,
immediately
get fresh air and
medical
help.
If
solvent
contacts
eyes,
immediately
wash
your
eyes
and get medical
aid.
Clean
all fittings
and area around
lubrication
points
with
dry cleaning
solvent
(Item
14, Appendix
E) or
equivalent
before
lubricating
equipment.
After lubri-
cation,
wipe off excess
oil or grease to prevent
accu-
mulation
of foreign
matter.
The lowest
level of maintenance
authorized
to lubri-
cate a point is indicated
in parentheses
by use of the
following:
(C) Operator/Crew;
or (O) Organizational
Maintenance.
3-2
Back to Top
