TM-9-2330-267-14-P
TRAILER, TANK, WATER: 400 GALLON, 1-1/2 TON, 2 WHEEL M149, M149A1 AND M149A2
TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)
JULY 1991
TM-9-2330-267-14-P - Page 160 of 354
TM 9-2330-267-14&P
4-57. WATER TANK BODY MAINTENANCE (STAINLESS STEEL).
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning and Refinishing Interior
Initial Setup;
Equipment Conditions:
Materials/Parts:
l Piping and faucets removed (para 4-58).
l Cleaning compound (Item 5, Appendix E)
l Rear faucet removed (para 4-59).
l Dry cleaning solvent (Item 9, Appendix E)
Tools/Test Equipment:
. Rags (Item 18, Appendix E)
l General mechanic’s tool kit
l Soap (item 22, Appendix E)
. Abrasive mask
l Bleach (Item 23, Appendix E)
c Air filter
l Lockwire (Item 29, Appendix E)
c Apron
s Four packings
l Blower
l Canvas sleeves
Personnel Required: Two
l Fresh air mask
References:
l Overhead hoist and sling, 10 ton
l Rubber gloves
l FM 21-10
l Safety rope
l Safety shoes
a .
REMOVAL
WARNING
All personnel must stand clear of hoist when raising or lowering water tank body. Failure
to follow this warning may result in serious injury or death to personnel.
1.
Install sling on water tank body (3) and connect to
suitable lifting device.
NOTE
There are four mounts. Two mounts are located
on each side of tank body.
2.
Cut and remove Iockwire (1) from four capscrews
(2). Discard Iockwire.
TA507068
4-110
Back to Top
