TM-9-2330-267-14-P

TRAILER, TANK, WATER: 400 GALLON, 1-1/2 TON, 2 WHEEL M149, M149A1 AND M149A2

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS)

JULY 1991

TM-9-2330-267-14-P - Page 151 of 354

TM 9-2330-267-14&P

4-53. RADIUS ROD MAINTENANCE (Con’t).

d.

INSTALLATION

1,

Aline radius rod (4) and two flatwashers (19) in bracket (20) and install sleeve bearing (21).

2.

Install two bushings (18) and shouldered washers (17) in bracket (20).

3.

Install cap screw (22), nut (16), and new locknut (15) in bracket (20).

4.

Tighten screw (14) on radius rod (4).

5.

Install bumper (13), flatwasher (12), new Iockwasher (11), and screw (10) in bracket (20).

6.

Install two bushings (9) and flatwashers (8) in bracket (5).

7.

Install radius rod (4) and sleeve bearing (3) in bracket (5).

8.

Install two shouldered washers (2), capscrew (1), nut (6), and new locknut (7).

e.

ADJUSTMENT]

NOTE

Ensure that distance between connectors is the same as that recorded when radius rod

was removed.

1.

Measure distance between connectors (23). If

measurement is the same as measurement

recorded during removal of radius rod, adjustment

is correct. If adjustment is not correct, go to step 2.

2.

Loosen screws (24) and turn rod (25) clockwise to

shorten and counterclockwise to lengthen dis-

tance between connectors (23).

3.

When measurement between connectors (23) is

same as that recorded during removal of radius

rod, tighten screws (24).

FOLLOW-ON TASKS:

l Install spring assembly (para 4-51).

TA507062

4-101