TM-9-2330-330-14-P

SEMITRAILER, FUEL TANKER: 5000-GALLON, FUEL-DISPENSING, AUTOMOTIVE, M969A3

TECHNICAL MANUAL; OPERATOR’S, ORGANIZATIONAL, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

NOVEMBER 2005

TM-9-2330-330-14-P - Page 375 of 1116

TM 9-2330-330-14&P

0076 00-1

AIR TUBING AND FITTINGS MAINTENANCE

0076 00

THIS WP COVERS:

Compression Sleeve Fittings Removal, Cleaning and Inspection, Compression Sleeve Fittings

Installation, Push-In Fittings Removal, Push-In Fittings Installation, Test, Follow-On Task

INITIAL SETUP:

Maintenance Level

Tools and Special Tools

Organizational

Tool kit, general mechanic’s (item 4, WP 0171 00)

Materials/Parts Equipment

Conditions

Compound, thread sealing (item 7, WP 0174 00)

Soap (item 12, WP 0174 00)

Semitrailer disconnected from prime mover (refer

to WP 0007 00)

Cable ties (AR) (item 98, WP 0175 00)

Semitrailer grounded (refer to WP 0007 00)

Compression sleeves (AR) (item 38, WP 0175 00)

Air reservoir drained (refer to WP 0007 00)

COMPRESSION SLEEVE FITTINGS REMOVAL

NOTE

All compression sleeve fittings are replaced the same way,

only the number of clips varies. This procedure replaces the

fittings and tubing between the Schrader valve and air reservoir.

1.

Disconnect tube nut (4) and tube (3) from fitting (2) at Schrader valve (1).

2.

Remove compression sleeve (5), insert (6), and tube nut (4) from tubing (3). Discard sleeve.