TM-9-2330-342-23-P

PALLETIZED LOAD SYSTEM TRAILER (PLST) M1076 A1

TECHNICAL MANUAL; FIELD MANUAL

OCTOBER 2012

TM-9-2330-342-23-P - Page 211 of 1348

CONDITION/INDICATION

Are 22 to 28 vdc measured on wire 1008C at diode assembly connector, terminals 10 and 12?

DECISION

Voltage OK - Replace diode assembly (WP

0059). Go to (Step 5 - Do all marker lights, and taillights, operate?) to

verify problem is solved.

Voltage Faulty - Go to (Step 4 - Can trailer main harness wire 1008C-6 be repaired?).

STEP 4

Can trailer main harness wire 1008C-6 be repaired?

WARNING

Remove all jewelry such as rings, ID tags, bracelets, etc. prior to working on or around vehicle.

Jewelry and tools can catch on equipment, contact positive electrical circuits, and cause a

direct short, severe burns, or electrical shock. Failure to comply may result in injury or death

to personnel.

NOTE

Wire is not repairable if damage cannot be visually located or if a prior repair has already

reduced length of wire. Wire is not repairable if after repair, wire is too short to reach its

connection point.

1.

Have assistant turn OFF lights. Refer to vehicle Operator's manual (WP

0190).

2.

Have assistant turn engine start switch to OFF. Refer to vehicle Operator's manual (WP

0190).

CONNECTOR

MC15

TRAILER

HARNESS

Figure 4.

Trailer Harness Connector MC15.

3.

Visually check if trailer main harness wire 1008C-6 can be repaired.

TM 9-2330-342-23&P

0016

0016-5