TM-9-2350-256-10
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
OPERATOR'S MANUAL
OCTOBER 2014
TM-9-2350-256-10 - Page 160 of 796
REMOVE/OPEN
Remove screws and washers to remove floor access plates or access doors (where applicable).
a.
Right front floor access plate (Figure 1, Item 1) — Remove floor access plate to access main winch fill
and level floor access door.
b.
Right front floor plate rear access (Figure 1, Item 2) — Remove floor access plate to access the
hydraulic hose connection.
c.
Access door (Figure 1, Item 3) — Lift on handle to lift floor access door to access the hoist winch fill
and level and main winch drain valve access door.
d.
Control valve forward right floor access plate (Figure 1, Item 4) — Remove floor access plate to
access the hydraulic hose connection floor access plate.
e.
Hand winch center right floor access door (Figure 1, Item 5) — Lift on handle to lift floor access door to
access the hoist winch drain valve access plate.
f.
Hydraulic line intermediate rear right center floor access door (Figure 1, Item 6) — Lift up on handle to
lift floor access door to access the hydraulic oil tank drain access door.
g.
Hydraulic connections access plate with seal (Figure 1, Item 7) — Remove floor access plate and seal
to access the hydraulic connections access door.
h.
Rear intermediate right floor access plate (Figure 1, Item 8) — Remove floor access plate to access
the hydraulic oil tank fill and oil level indicator floor access plate.
i.
Rear center floor access door (Figure 1, Item 9) — Remove floor access door to access the hydraulic
filter gauge, mechanical fill level indicator, and drain valve access door.
j.
Fuel transmitter center left floor access door (Figure 1, Item 10) — Remove floor access plate to
access fuel level sending unit and fuel pump.
k.
Intermediate rear left floor access door (Figure 1, Item 11) — Lift up on handle to lift up floor access
door to access BII components (WP 0132).
l.
Stowage basket forward intermediate left floor access door (Figure 1, Item 12) — Crewman seat must
be removed before opening floor access door. Lift up on handle to open floor access door to access
BII components (WP 0132).
m.
Access plate (Figure 1, Item 13) — Remove power cable prior to opening floor access plate to access
the winch compartment light mount plate.
TM 9-2350-256-10
0027
0027-2
Back to Top
