TM-9-2350-256-10
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
OPERATOR'S MANUAL
OCTOBER 2014
TM-9-2350-256-10 - Page 495 of 796
TRANSMISSION TROUBLESHOOTING
INITIAL SETUP:
Materials/Parts
Wiping rags Qty: AR (WP 0134, Table 1, Item 57)
Personnel Required
Crewman (3)
References
Description and use of operator's controls and
indicators (WP 0004)
Hull access covers and gasket replacement
(WP 0104)
References (cont.)
Normal engine operation (WP 0011)
Preventive Maintenance Checks and Services
(PMCS) – after, including lubrication
instructions (WP 0098)
Starting main engine (WP 0010)
Track tension adjustment (new configuration)
(WP 0110)
Track tension adjustment (old configuration)
(WP 0109)
Transmission shift selection (WP 0012)
WARNING
•
Hot engine surfaces can ignite engine oil. Clean oil from around oil filler tube area
with wiping rags after filling. Ensure engine oil filler tube cap is tight and engine oil
fill access door is closed and latched. Failure to comply may result in personnel
death, injury, and/or damage to equipment.
•
Fuel/solvent/oil is slippery and may cause falls. Wipe up spillage immediately with
rags. Dispose of materials in accordance with local hazardous waste disposal
procedures. Failure to comply may result in personnel death, injury, or damage
to equipment.
TROUBLESHOOTING PROCEDURE
VEHICLE WILL NOT DRIVE IN FORWARD OR REVERSE GEARS
SYMPTOM
Vehicle will not drive in forward or reverse gears.
MALFUNCTION
Shift linkage is bent, missing, improperly adjusted, or contains loose parts.
CORRECTIVE ACTION
1.
Check for bent, missing, or improperly adjusted shift linkage or if linkage contains loose parts.
2.
If there are bent, missing, or improperly adjusted shift linkages or loose parts, notify
maintenance.
TM 9-2350-256-10
0092
0092-1
Back to Top
